Author Topic: Mouse Setup  (Read 1162 times)

Offline Aracelis

  • NPC
  • *
  • Posts: 2
Mouse Setup
« on: October 12, 2014, 02:25:32 PM »
Please I need help to set the mouse up. I'm not able to incline the camera with the wheel, even with TS3 camera mode selected.

I have a Microsoft Wireless Mouse 2000.

Can someone point me the right setup for Intellipoint, please?

TIA. :)

Offline Flynn Arrowstarr

  • Administrator
  • Immortal
  • ******
  • Posts: 797
  • Semi-conscious
Re: Mouse Setup
« Reply #1 on: October 12, 2014, 05:47:12 PM »
Hi, Aracelis.

If you have the Microsoft Keyboard and Mouse Center application installed (it can be installed at device installation or through Windows Update), it changes the default behavior of the middle mouse button. The default action is called Flip. You need to open the Keyboard and Mouse Center program and change the middle mouse button (called the wheel button in the software) to Middle Click and the incline should work like it's supposed to.

Hope this helps and happy Simming! :)

Flynn

Check out Flynn's Fineries for houses, Sims and helpful articles.

Read and heed the Forum Rules, please!



Registered members do not see ads on this Forum. Register here.

Offline Aracelis

  • NPC
  • *
  • Posts: 2
Re: Mouse Setup
« Reply #2 on: October 14, 2014, 01:10:49 AM »
It is already set to middle, Flynn. And it still doesn't work.   :( But I found out that you can use CTRL+ right button, and it does work. I guess I'll have to get used to that. But thanks, that was a good advice.

Offline Flynn Arrowstarr

  • Administrator
  • Immortal
  • ******
  • Posts: 797
  • Semi-conscious
Re: Mouse Setup
« Reply #3 on: October 14, 2014, 02:15:35 AM »
Hmm.. the other possibility is the mouse button is going bad. I had that problem with an earlier wireless mouse. Do you have another mouse lying around you can try? Nice to know about the CTRL + RMB to tilt the camera. I'll have to give that a try as well. :)

Flynn
Check out Flynn's Fineries for houses, Sims and helpful articles.

Read and heed the Forum Rules, please!